SQUARE COUNTERFLOW COOLING TOWER
KFT counter flow, Square Type, Modular Cell Cooling Tower Features: 1)Package type, with FRP structure, casing & basin 2)With high efficiency, air vacuum forming type PVC fills. 3)With fixed water spray nozzles. 4)with drift eliminator 5)with silent mat above water basin Capacity range:...
KFT counter flow, Square Type, Modular Cell Cooling Tower
1)Package type, with FRP structure, casing & basin
2)With high efficiency, air vacuum forming type PVC fills.
3)With fixed water spray nozzles.
4)with drift eliminator
5)with silent mat above water basin
Available in 22 standard models (single cell) with capabilities from 40 to 1000 nominal tons. (Various modular combinations are available to meet different cooling capacity requirements and jobsite restrictions.)
Heating, ventilation, air-conditioning, and light to medium processing applications.
2)Smaller footprint, taking up less site space.
3)Low noise and less drifting loss
4)Easy to install
5)Light in operating weight
6)Lower piping & control system cost
7)Easy for maintenance
8)Long service life
1.Long-durability and light-weight:
Tower body is made out of F.R.P. (fiberglass reinforced plastics) which is free from corrosion, so it is as durable as steel but as light as P.V.C.. What’s more, being coated with a special epoxy composed of anti-ultraviolet agent, the tower body is also resistant to the hurt from sunlight.
All steel parts are treated by H.D.G. (hot dip galvanization), so none will get rusty.
With specially designed axial fan and belt reducer, the tower holds in itself strong wind but very low noise. In addition, there is a high quality silence mat above the basin that will absorb most of water drop noise.
4.Low water loss:
The specially designed PVC drift eliminator can produce excellent efficiency at stopping spray, so the carry-over volume can always be kept within 0.002%, and only a slight pressure drop loss will be caused there.
5.No clog & pollution:
All nozzles are designed to be with special big orifice so they will not get clogged as what were usually used. Moreover, being installed inside the towers, nor will the nozzles accept dirt’s from environmental pollution.
6.Good heat-exchange efficiency:
The film type cellular fill is made of air vacuum forming PVC sheets which are with corrugated surface and are disposed at cross against each other, so it can do very good job in heat rejection.
7.Light operating weight:
With shape sloping down into water sump, the basin requires less water storage than common square type basins, so the tower will not carry too much weight during operation. The water sump however is at special large size, so it takes no risk of sucking in air.
All tower supports are made of FRP and are body-formed with basin, so it is very easy to erect the tower, no matter there’s isolation steel frame or not.